The Wing Boss

8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority.

General. time without temperature control. except as specified under subitem d of this item, when time without temperature control is used as the public health control for a working supply of time/temperature controlled for safety (tcs) food before cooking, or for ready to eat time/temperature controlled for safety (tcs) food that is displayed or held for service written procedures not prepared in advance, maintained in the food establishment / not made available to the regulatory authority upon request. these written procedures shall specify methods of compliance with subitems b[01]-[03] or c[01]-[05] of this item; and methods of compliance with section 20-21.03(b)(02) of this code for food that is prepared, cooked, and refrigerated before time is used as a public health control.

General. when time without temperature control is used as the public health control up to a maximum of four hours: food was not marked or otherwise identified to indicate the time that is four hours past the point in time when the food was removed from temperature control.

Cross contamination. except as specified in subitem c of this item, food not protected from cross contamination by separating raw animal foods during storage, preparation, holding and display from: raw ready to eat foods including other raw animal food such as fish for sushi or molluscan shellfish or other raw ready to eat food such as vegetables; cooked ready to eat foods. frozen, commercially processed and packaged raw animal food may be stored or displayed with or above frozen, commercially processed and packaged, ready to eat food.

General. raw / prepared food removed from original containers / packages being stored in unclean containers / being stored in uncovered containers.. (corrected on site)

Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.

Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.

Wiping cloths. moist cloths used for wiping food spills on kitchenware and food-contact surfaces of equipment not clean / not rinsed frequently in one of the sanitizing solutions permitted in section 20-21.12(e)(02) through (06) of this code / used for no other purpose. these cloths shall be stored in the sanitizing solution between uses. (corrected on site)

Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.

Containers. in containers designed with drains, drain plugs not in place at all times, except during cleaning.

Controlling pests, generally. effective measures intended to eliminate the presence of rodents, flies, cockroaches, and other insects on the premises not utilized.

Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be kept clean.

Floor junctures. in all new or extensively remodeled establishments utilizing concrete / terrazzo / ceramic tile / similar flooring materials, and where water flush cleaning methods are used, the junctures between walls and floors not coved / not sealed. in all other cases, the juncture between walls and floors shall not present an open seam of more than one-thirty-second of an inch.

Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not maintained in good repair.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

Construction. walls, including nonsupporting partitions / wall coverings / ceilings, of walk-in refrigerating units / food preparation areas / food storage areas / food display areas / equipment-washing areas / utensil-washing areas not light-colored / smooth / nonabsorbent / easily cleanable except for ceilings over areas used only for beverage preparation and/or service. concrete or pumice blocks used for interior wall construction in these locations shall be finished and sealed to provide an easily cleanable surface except in dry storage areas.

Food establishment failed to maintain on premises a certificate of completion of the food handler course for each food employee.