Kroger #314

Hot or cold food held at improper temperature (corrected on site)

Physical facilities not cleaned at required frequency

Physical facilities not in good repair

No certified food protection manager

Before engaging in an activity that requires a haccp plan, a permit applicant or permit holder shall submit to the regulatory authority for approval a properly prepared haccp plan as specified under § 8-201.14 and the relevant provisions of this code if: (1) submission of a haccp plan is required according to law; (2) a variance is required as specified under subparagraph 3-401.11(d)(4), § 3-502.11, or ¶ 4-204.110(b); (3) the regulatory authority determined that a food preparation or processing method requires a variance based on a plan submittal specified under § 8-201.12, an inspectional finding, or a variance request.

Equipment or utensils not clean

No written procedures for vomiting or diarrheal events (corrected on site)

The water source and system shall be of sufficient capacity to meet the peak water demands of the food establishment

No certified food protection manager

Before engaging in an activity that requires a haccp plan, a permit applicant or permit holder shall submit to the regulatory authority for approval a properly prepared haccp plan as specified under § 8-201.14 and the relevant provisions of this code if: (1) submission of a haccp plan is required according to law; (2) a variance is required as specified under subparagraph 3-401.11(d)(4), § 3-502.11, or ¶ 4-204.110(b); (3) the regulatory authority determined that a food preparation or processing method requires a variance based on a plan submittal specified under § 8-201.12, an inspectional finding, or a variance request.

Food shall be offered for human consumption in a way that does not mislead or misinform the consumer. (corrected on site)

Evidence of pests or pest control inadequate

Food stored improperly or exposed to contamination (corrected on site)

Equipment or utensils not clean

Physical facilities not cleaned at required frequency

Physical facilities not in good repair

8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority.

General. time without temperature control. except as specified under subitem d of this item, when time without temperature control is used as the public health control for a working supply of time/temperature controlled for safety (tcs) food before cooking, or for ready to eat time/temperature controlled for safety (tcs) food that is displayed or held for service written procedures not prepared in advance, maintained in the food establishment / not made available to the regulatory authority upon request. these written procedures shall specify methods of compliance with subitems b[01]-[03] or c[01]-[05] of this item; and methods of compliance with section 20-21.03(b)(02) of this code for food that is prepared, cooked, and refrigerated before time is used as a public health control.

General. when time without temperature control is used as the public health control up to a maximum of four hours: food was not marked or otherwise identified to indicate the time that is four hours past the point in time when the food was removed from temperature control. (corrected on site)

Refrigerated storage. refrigeration facilities. the sensor of a temperature measuring device shall be located to measure the air temperature or a simulated product temperature in the warmest part of the mechanically refrigerated unit and designed to be easily readable.

Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.

Materials; general. all equipment and utensils not maintained in good repair.

Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.

Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.

Hand-washing signage. sign / icon / poster that notifies food employees to wash their hands not provided at all hand-washing sinks used by food employees / not clearly visible to food employees.

Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning. (corrected on site)

Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be constructed of smooth durable materials such as sealed concrete, terrazzo, ceramic tile, vinyl, plastic, or tight wood impregnated with vinyl or plastic.

Floor junctures. in all new or extensively remodeled establishments utilizing concrete / terrazzo / ceramic tile / similar flooring materials, and where water flush cleaning methods are used, the junctures between walls and floors not coved / not sealed. in all other cases, the juncture between walls and floors shall not present an open seam of more than one-thirty-second of an inch.

Cleaning physical facilities. general. floor mats / duckboards / walls / ceilings / attached equipment and decorative materials not kept clean. only dustless methods of cleaning floors and walls shall be used, such as vacuum cleaning, wet cleaning, or the use of dust-arresting sweeping compounds with brooms.

General. physical facilities not maintained in good repair.

Food establishment failed to maintain on premises a certificate of completion of the food handler course for each food employee.

8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority.

Refrigerated storage. refrigeration facilities. each mechanically refrigerated facility storing time/temperature controlled for safety (tcs) food shall be provided with numerically scaled indicating thermometer, accurate to 3°f if scaled in fahrenheit only. . recording thermometers, accurate to 3°f if scaled in fahrenheit only, may be used in lieu of indicating thermometers. thermometers that are scaled in celsius or dually scaled in celsius and fahrenheit shall be designed to be easily readable and accurate to ±(1.05°c) in the intended range of use.

Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.

Single-service articles. single-service and single-use articles not handled / displayed / dispensed in a manner that prevents contamination of surfaces that may come in contact with food or with the mouth of the user. (corrected on site)

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be maintained in good repair.

Floor junctures. when allowed in this subsection, the juncture between walls and floors presenting an open seam of more than one-thirty-second of an inch.

Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not maintained in good repair.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.