The French Corner Catering
Last inspected: Apr 28, 2026
100
Score
The health department has logged five inspections at The French Corner Catering, the earliest from 2024. The French Corner Catering was last inspected on Apr 28, 2026. Low risk means the most recent visit produced few or no significant findings.
Things have been moving in the right direction, with the rolling count dropping from around 16 violations to closer to zero violations per visit.
The most common issue across all inspections has been “food establishment failed to maintain on premises a certificate”, showing up three times.
That puts the facility ahead of the local pack: the average Houston restaurant scores 88. Overall, the inspection record reads well.
5
Inspections
0
Critical latest
0
Major latest
0
Minor latest
Inspection History
Apr 28, 2026
Routine
No violations found.
100
Sep 24, 2025
Reinspection (002)
19 minor violations. 2 corrected on site.
View 19 violations
General. at all times, including while being stored, prepared, displayed, served, received, or transported, food not protected from potential contamination by all agents, including dust, insects, rodents, toxic materials, cross-contamination, damaged or spoiled products, distressed merchandise, recalled products, unclean equipment and utensils, unnecessary handling, coughs and sneezes, flooding, draining, and overhead leakage or overhead drippage from condensation.
(corrected on site)
20-21.02(a)(01)
General. raw / prepared food removed from original containers / packages being stored in unclean containers / being stored in uncovered containers..
20-21.03(a)(01)
General. bulk food removed from original container not stored in a container identifying the food by common name.
20-21.03(a)(06)
Refrigerated storage. date marking of ready to eat foods. time/temperature controlled for safety (tcs) / ready to eat food opened / prepared / packaged and held refrigerated for more than 24 hours not clearly marked to indicate “time food is opened / prepared” and “disposition date”.
(corrected on site)
20-21.03(b)(10)b
Dispensing utensils. no suitable dispensing utensils provided for employees / consumers during pauses in food preparation / dispensing.
20-21.05(f)
Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.
20-21.11(a)(07)
Storage. utensils and equipment not air-dried before being stored / not stored in a self-draining position. utensils and equipment may not be cloth-dried except that utensils that have been air-dried may be polished with cloths that are maintained clean and dry.
20-21.14(b)(02)
Storage. cleaned and sanitized utensils and movable equipment not stored at least six inches above the floor in a clean, dry location in a way that protects them from contamination by splash, dust, and other means.
20-21.14(b)(01)
Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.
20-21.17(c)
Hand-washing signage. sign / icon / poster that notifies food employees to wash their hands not provided at all hand-washing sinks used by food employees / not clearly visible to food employees.
20-21.19(g)
Hand-washing sink maintenance. hand-washing sink / soap dispenser / hand-drying device/ related fixtures not kept clean / not in good repair.
20-21.19(d)
Removing dead or trapped birds / insects / rodents / other pests. dead or trapped birds / insects / rodents / other pests not removed from control devices and the premises at a frequency that prevents the accumulation or attraction of pests and minimizes exposure to decomposing remains.
20-21.21(d)
Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.
20-21.21(b)
Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be maintained in good repair.
20-21.22(a)
Floor junctures. in all new or extensively remodeled establishments utilizing concrete / terrazzo / ceramic tile / similar flooring materials, and where water flush cleaning methods are used, the junctures between walls and floors not coved / not sealed. in all other cases, the juncture between walls and floors shall not present an open seam of more than one-thirty-second of an inch.
20-21.22(f)
Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not kept clean.
20-21.23(a)
Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.
20-21.23(g)
General. food establishment and all parts of the property used in connection with operations of the establishment not kept free of litter and items that are unnecessary to the operation or maintenance of the establishment, such as equipment that is nonfunctional or no longer in use.
20-21.28(a)(01)
Food establishment failed to maintain on premises a certificate of completion of the food handler course for each food employee.
20-53(g)
39
Jun 2, 2025
Routine Inspection (001)
14 minor violations. 2 corrected on site.
View 14 violations
8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority.
20-20(c)
General. at all times, including while being stored, prepared, displayed, served, received, or transported, food not protected from potential contamination by all agents, including dust, insects, rodents, toxic materials, cross-contamination, damaged or spoiled products, distressed merchandise, recalled products, unclean equipment and utensils, unnecessary handling, coughs and sneezes, flooding, draining, and overhead leakage or overhead drippage from condensation.
20-21.02(a)(01)
Cross contamination. except as specified in subitem c of this item, food not protected from cross contamination by separating raw animal foods during storage, preparation, holding and display from: raw ready to eat foods including other raw animal food such as fish for sushi or molluscan shellfish or other raw ready to eat food such as vegetables; cooked ready to eat foods. frozen, commercially processed and packaged raw animal food may be stored or displayed with or above frozen, commercially processed and packaged, ready to eat food.
(corrected on site)
20-21.02(b)(01)
General. container of food not stored a minimum of 6 inches above the floor.
20-21.03(a)(02)
Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.
20-21.10(m)
Materials; general. all equipment and utensils not maintained in good repair.
20-21.10(a)
Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.
20-21.11(a)(07)
Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.
20-21.17(c)
Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.
20-21.20(a)(03)
Removing dead or trapped birds / insects / rodents / other pests. dead or trapped birds / insects / rodents / other pests not removed from control devices and the premises at a frequency that prevents the accumulation or attraction of pests and minimizes exposure to decomposing remains.
(corrected on site)
20-21.21(d)
Controlling pests, generally. effective measures intended to eliminate the presence of rodents, flies, cockroaches, and other insects on the premises not utilized.
20-21.21(a)
Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be maintained in good repair.
20-21.22(a)
Floor drains. properly installed trapped floor drains not provided in floors that are water-flushed for cleaning / that receive discharges of water or other fluid waste from equipment / in areas where pressure spray methods for cleaning equipment are used. the floors shall be constructed only of sealed concrete, terrazzo, ceramic tile or similar materials, and shall be graded to drain.
20-21.22(d)
Food establishment failed to maintain on premises a certificate of completion of the food handler course for each food employee.
20-53(g)
50
Oct 15, 2024
Routine Inspection (001)
5 minor violations. 1 corrected on site.
View 5 violations
Refrigerated storage. date marking of ready to eat foods. time/temperature controlled for safety (tcs) / ready to eat food opened / prepared / packaged and held refrigerated for more than 24 hours not clearly marked to indicate “time food is opened / prepared” and “disposition date”.
(corrected on site)
20-21.03(b)(10)b
Using chemicals for sanitization. when using chemicals for sanitization, a test kit or other device that accurately measures the concentration of the solution in parts per million or milligrams per liter not provided and used.
20-21.12(g)
General. plumbing not sized / installed / maintained according to applicable laws.
20-21.17(a)
Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.
20-21.21(b)
Food establishment failed to maintain on premises a certificate of completion of the food handler course for each food employee.
20-53(g)
78
Feb 9, 2024
Routine Inspection (001)
5 minor violations.
View 5 violations
Refrigerated storage. refrigeration facilities. each mechanically refrigerated facility storing time/temperature controlled for safety (tcs) food shall be provided with numerically scaled indicating thermometer, accurate to 3°f if scaled in fahrenheit only. . recording thermometers, accurate to 3°f if scaled in fahrenheit only, may be used in lieu of indicating thermometers. thermometers that are scaled in celsius or dually scaled in celsius and fahrenheit shall be designed to be easily readable and accurate to ±(1.05°c) in the intended range of use.
20-21.03(b)(01)
Materials; general. materials not sufficient in weight and thickness to withstand repeated cleaning and sanitizing / not resistant to pitting, chipping, crazing, scratching, scoring, distortion, and decomposition except for single-service and single-use articles.
20-21.10(a)
Wiping cloths. moist cloths used for cleaning nonfood-contact surfaces of equipment such as counters, dining table tops and shelves not clean / not rinsed frequently in one of the sanitizing solutions permitted in section 20-21.12(e)(02) through (06) of this code / used for no other purpose. these cloths shall be stored in the sanitizing solution between uses.
20-21.11(c)(03)
Floor junctures. when allowed in this subsection, the juncture between walls and floors presenting an open seam of more than one-thirty-second of an inch.
20-21.22(f)
Attachments. decorative materials in consumer areas attached to walls and ceilings not maintained in good repair / not kept clean.
20-21.23(g)
78
Frequently Asked Questions
When was The French Corner Catering last inspected?
The most recent health inspection at The French Corner Catering on file is from Apr 28, 2026. The public record contains five inspections in total.
What is the most common violation at The French Corner Catering?
Across the inspection record, “food establishment failed to maintain on premises a certificate” has been cited three times, more than any other issue at The French Corner Catering.
How does The French Corner Catering compare to other restaurants in Houston?
The French Corner Catering most recently scored 100 out of 100, which is higher than the Houston average of 88.
Has The French Corner Catering's inspection record improved over time?
Yes. Recent inspections at The French Corner Catering have averaged around zero violations per visit, down from roughly 16 earlier in the record.
What does a low risk rating mean?
A low risk rating at The French Corner Catering means inspectors found minimal or no significant issues at the most recent visit. Most facilities at this tier have a clean recent inspection report.
How often is The French Corner Catering inspected?
Based on the inspection history on file, The French Corner Catering is inspected around two times per year on average.
Nearby Restaurants