Tastee Buddies
Last inspected: Oct 6, 2025
82
Score
An inspection of Tastee Buddies at 11300 Bissonnet St, Houston, TX, on October 6, 2025, resulted in a low-risk score of 82. The inspection identified four minor violations, including issues with food storage, employee training on food safety and reporting, and the absence of written procedures for responding to vomiting or diarrheal events. Additionally, plumbing fixtures were not installed to prevent splashes from running down mounting surfaces.
1
Inspections
0
Critical latest
0
Major latest
4
Minor latest
Inspection History
Oct 6, 2025
Routine
4 minor violations.
82
Violations — Oct 6, 2025 Inspection
Applicability of article; compliance; penalty for violation; variances, etc. permit holder / person in charge of the food establishment / mobile food unit not in compliance in accordance with provisions of article ii concerning food storage / food preparation / food display / training of employees in basic food safety principles including allergy awareness / not ensuring that food and conditional employees are informed of their responsibility to report information regarding health and activities as they relate to diseases that are transmissible through food / not ensuring written procedures and plans are developed by the food establishment are maintained / implemented.
20-19(d)
General. contamination event. food establishment without written procedures for employees to follow when responding to vomiting or diarrheal events.
20-21.07(a)(03)
Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.
20-21.10(m)
Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.
20-21.17(c)
Substantial (Critical)
Serious (Major)
General (Minor)
Nearby Restaurants