Starbucks Coffee #8134

Refrigerated storage. refrigeration facilities. each mechanically refrigerated facility storing time/temperature controlled for safety (tcs) food shall be provided with numerically scaled indicating thermometer, accurate to 3°f if scaled in fahrenheit only. . recording thermometers, accurate to 3°f if scaled in fahrenheit only, may be used in lieu of indicating thermometers. thermometers that are scaled in celsius or dually scaled in celsius and fahrenheit shall be designed to be easily readable and accurate to ±(1.05°c) in the intended range of use.

Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.

Cleaning frequency. dry cleaning. surfaces of utensils and equipment contacting food that is not time/temperature controlled for safety (tcs) food not cleaned in equipment such as ice bins, beverage dispensing nozzles, enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment at a frequency specified by the manufacturer; or absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold. this subsection does not apply when dry cleaning methods are used as specified in subitems a and b of this item.

Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.

Testing of the final rinse temperature not done by means of an irreversible registering temperature indicator or heat sensitive indicating paper traveling through the final rinse chamber in the same manner as equipment and utensils, at the dish level during a normal rinse cycle.

Single-service articles. single-service and single-use articles not stored at least six inches (15 cm) above the floor on dollies / pallets / racks / skids designed as specified under section 20-21.03(a)2b of this code / not kept in closed cartons that protect them from contamination, except for automatic fire protection sprinkler heads that may be required by law.

Water under pressure. hot water is greater than or equal to 100°f (38°c) but less than 105°f (41°c). minimum acceptable temperature is 110°f (43°c) except as specified in section 20-21.12(d)(02) and 20-21.19(b) of this code. hot water generation and distribution systems shall be sufficient to meet the peak hot water demand throughout the food establishment.

Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be kept clean.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.