New Era Food Store

8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority.

Special requirements. manufactured food. all food manufactured, processed, or packaged in commercial food processing establishments or commissaries not labeled according to all applicable laws as defined in tfer 228.78 and 228.79.

General. the internal temperature of time/temperature controlled for safety (tcs) food not maintained at 41°f (05°c) or below or 135°f (57°c) or above at all times, except as otherwise provided in this article or unless a packaged product is so labeled as exempted and approved by the appropriate state or federal health authority. (corrected on site)

Temperature measuring device, food. food temperature measuring devices accurate to ±02°f in the intended range of use not provided / not used to assure attainment and maintenance of proper internal cooking, holding, or refrigeration temperatures of all time/temperature controlled for safety (tcs) food if the thermometers are scaled only in fahrenheit. if the thermometers are scaled in celsius or dually scaled, they shall be accurate to ±01°c in the intended range of use. a temperature measuring device with a suitable small-diameter probe that is designed to measure the temperature of thin masses not provided / not readily accessible to accurately measure the temperature in thin foods, such as meat patties and fish fillets.

Materials; general. all equipment and utensils not maintained in good repair.

Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.

Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.

Using chemicals for sanitization. when using chemicals for sanitization, a test kit or other device that accurately measures the concentration of the solution in parts per million or milligrams per liter not provided and used.

Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.

Hand-washing sink supplies. hand-washing sink or group of adjacent hand-washing sinks not provided with individual, disposable towels / a continuous towel system that supplies the user with a clean towel / a hand-drying device providing heated air or a hand-drying device that employs an air-knife system that delivers high velocity, pressurized air at ambient temperatures.

Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.

Floor junctures. in all new or extensively remodeled establishments utilizing concrete / terrazzo / ceramic tile / similar flooring materials, and where water flush cleaning methods are used, the junctures between walls and floors not coved / not sealed. in all other cases, the juncture between walls and floors shall not present an open seam of more than one-thirty-second of an inch.

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be kept clean.

Construction. walls, including nonsupporting partitions / wall coverings of toilet rooms and vestibules, not smooth / nonabsorbent / easily cleanable. concrete or pumice blocks used for interior wall construction in these locations shall be finished and sealed to provide an easily cleanable surface except in dry storage areas.

Maintenance. walls / ceilings, including doors, windows, skylights, and similar closures, not maintained in good repair.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

Protective shielding. light bulbs not shielded / coated / otherwise shatter-resistant in areas where there is exposed food, clean equipment / utensils / linens / unwrapped single-service or single-use articles, except as specified in subitems a and b of this item shielded / coated / otherwise shatter-resistant bulbs need not be provided in areas used only for storing food and single-service articles in unopened packages if the integrity of the packages cannot be affected by broken glass falling onto them and the packages are capable of being cleaned of debris from broken bulbs before the packages are opened.

Cleaning equipment storage. after use, mops not placed in a position that allows them to air-dry without soiling walls / equipment / supplies.

General. food establishment and all parts of the property used in connection with operations of the establishment not kept free of litter and items that are unnecessary to the operation or maintenance of the establishment, such as equipment that is nonfunctional or no longer in use.

General. equipment / utensils not in current use not stored in a clean and sanitary condition.