Loro

Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.

Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed. (corrected on site)

Dispensing utensils not stored in water at least 135°f (57°c) / water container is not cleaned as often as necessary. (corrected on site)

Hand-washing sink installation. hand-washing sink not accessible to employees at all times. (corrected on site)

Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be maintained in good repair.

Hot storage. time/temperature controlled for safety (tcs) food in hot storage not being held at 135°f (57°c) or above. (corrected on site)

Containers. in containers designed with drains, drain plugs not in place at all times, except during cleaning.

Storage. facilities for the storage of knives, forks, and spoons shall be designed and used to present the handle to the employee or consumer. (corrected on site)

Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.