La Jiraldilla Bakery

Applicability of article; compliance; penalty for violation; variances, etc. operating a food service / processing establishment not conforming to requirements of article ii.

8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority.

Water under pressure. hot water is less 100°f (38°c). minimum acceptable temperature is 110°f (43°c) except as specified in section 20-21.12(d)(02) and 20-21.19(b) of this code. hot water generation and distribution systems shall be sufficient to meet the peak hot water demand throughout the food establishment.

General. plumbing not sized / installed / maintained according to applicable laws.

Openings. outside openings not protected against the entrance of insects by filling or closing holes and other gaps along floors / walls / ceilings / tight-fitting, self-closing doors, kept closed / closed windows / screening / properly designed and installed air curtains to control flying insects / other means.

Special ventilation. filters not cleaned at sufficient frequency to prevent accumulation.

Refrigerated storage. refrigeration facilities. each mechanically refrigerated facility storing time/temperature controlled for safety (tcs) food shall be provided with numerically scaled indicating thermometer, accurate to 3°f if scaled in fahrenheit only. . recording thermometers, accurate to 3°f if scaled in fahrenheit only, may be used in lieu of indicating thermometers. thermometers that are scaled in celsius or dually scaled in celsius and fahrenheit shall be designed to be easily readable and accurate to ±(1.05°c) in the intended range of use.

General. contamination event. food establishment without written procedures for employees to follow when responding to vomiting or diarrheal events.

Manual sanitizing. food-contact surfaces of all equipment and utensils not sanitized by rinsing, spraying, or swabbing with a chemical sanitizing solution at the strength required for that particular sanitizing solution under items 20-21.12(e)(02) through 20-21.12(e)(06) above, in the case of equipment too large to sanitize by immersion.

Manual sanitizing. food-contact surfaces of all equipment and utensils not sanitized by immersion in a chlorine solution in a manner that complies with one of the following; 25 ppm at a minimum temperature of 120of for 10 seconds when ph is <=10, 50 ppm at a minimum temperature of 100of for 7 seconds when ph is <=10, 50 ppm at a minimum temperature of 75of for 7 seconds when ph is <=8, or 100 ppm at a minimum temperature of 55of for 10 seconds when ph is <=10.

Storage. holders for knives, forks and spoons at self-service locations not protecting these articles from contamination and presenting the handle of the utensil to the consumer, except for prewrapped tableware.

Single-service articles. single-service and single-use articles used more than once.

Controlling pests, generally. the presence of insects, rodents, and other pests shall be controlled to eliminate their presence within the physical facility and its contents and on the contiguous land or property under the control of the permit holder by using appropriate methods of pest control, such as trapping devices or other means of pest control as specified under section 20-21.27 of this code.\r\n

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

Sanitation poster not conspicuously posted in area accessible to all employees / not conforming to all requirements.