Clean Juice

Materials; general. all equipment and utensils not maintained in good repair.

Applicability of article; compliance; penalty for violation; variances, etc. operating a food service / processing establishment not conforming to requirements of article ii.

8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority.

Hair restraint. while handling food or utensils, food employees not wearing effective hair restraints and clothing that covers body hair to prevent the contamination of food or food-contact surfaces. an effective hair restraint means any cap / hat / hair net made of fabric / cord / plastic / paper that effectively covers and holds hair in place. the use of effective hair restraints also applies to any exposed scalp or facial hair where there is the potential for contamination of food or food-contact surfaces. an effective hair restraint shall also be used in the partial or complete absence of scalp hair to preclude touching of the scalp and returning to food handling without hand-washing. facial hair restraints are not be required when facial hair is well-groomed and trimmed.

Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.

Water under pressure. hot water is at least 105°f (41°c)but less than 110°f (43°c). minimum acceptable temperature is 110°f (43°c) except as specified in section 20-21.12(d)(02) and 20-21.19(b) of this code. hot water generation and distribution systems shall be sufficient to meet the peak hot water demand throughout the food establishment.

Hand-washing sink supplies. supply of hand-cleansing liquid / powder / bar soap not available at each hand-washing sink or group of two adjacent hand-washing sinks.

Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.

Refrigerated storage. date marking of ready to eat foods. time/temperature controlled for safety (tcs) / ready to eat food opened / prepared / packaged and held refrigerated for more than 24 hours not clearly marked to indicate “time food is opened / prepared” and “disposition date”. (corrected on site)

Hand-washing sink supplies. hand-washing sink or group of adjacent hand-washing sinks not provided with individual, disposable towels / a continuous towel system that supplies the user with a clean towel / a hand-drying device providing heated air or a hand-drying device that employs an air-knife system that delivers high velocity, pressurized air at ambient temperatures.

Controlling pests, generally. effective measures intended to eliminate the presence of rodents, flies, cockroaches, and other insects on the premises not utilized.

Labeling of materials. working containers used for storing poisonous / toxic materials such as cleaners and sanitizers taken from bulk supplies not clearly / individually identified with the common name of the material. (corrected on site)

8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority.

Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

General. the traffic of unnecessary persons through the food preparation and utensil-washing areas is prohibited.

Food establishment failed to maintain on premises a certificate of completion of the food handler course for each food employee.