Bill's Cafe

Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.

General. time without temperature control. except as specified under subitem d of this item, when time without temperature control is used as the public health control for a working supply of time/temperature controlled for safety (tcs) food before cooking, or for ready to eat time/temperature controlled for safety (tcs) food that is displayed or held for service written procedures not prepared in advance, maintained in the food establishment / not made available to the regulatory authority upon request. these written procedures shall specify methods of compliance with subitems b[01]-[03] or c[01]-[05] of this item; and methods of compliance with section 20-21.03(b)(02) of this code for food that is prepared, cooked, and refrigerated before time is used as a public health control.

Refrigerated storage. cold storage of foods. time/temperature controlled for safety (tcs) food not maintained at 41°f (5°c) in cold storage. (corrected on site)

Materials; general. all equipment and utensils not maintained in good repair.

Cleaning frequency. dry cleaning. surfaces of utensils and equipment contacting food that is not time/temperature controlled for safety (tcs) food not cleaned in equipment such as ice bins, beverage dispensing nozzles, enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment at a frequency specified by the manufacturer; or absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold. this subsection does not apply when dry cleaning methods are used as specified in subitems a and b of this item.

Using chemicals for sanitization. when using chemicals for sanitization, a test kit or other device that accurately measures the concentration of the solution in parts per million or milligrams per liter not provided and used.

Manual sanitizing. food-contact surfaces of all equipment and utensils not sanitized by immersion in a quaternary ammonium compound solution at a concentration according to the manufacturer’s label at a minimum temperature of 75f for an exposure time according to the manufacturer’s label. (corrected on site)

Containers. containers stored outside the establishment / dumpsters / compactors / compactor systems / receptacles / waste handling units for refuse / recyclables / and returnables not provided with tight-fitting lids / doors / covers, not kept covered when not in actual use. in containers designed with drains, drain plugs shall be in place at all times, except during cleaning.

Insect control devices, design and installation. devices used to trap insects by adherence may not be installed above exposed food / clean equipment / utensils / linens and unwrapped single-service articles. (corrected on site)

Floors. floors and floor coverings of all food preparation, food storage, utensil-washing areas, walk-in refrigerating units, dressing rooms, locker rooms, and toilet rooms shall be kept clean.

Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.

Special ventilation. filters not cleaned at sufficient frequency to prevent accumulation.

Labeling of materials. working containers used for storing poisonous / toxic materials such as cleaners and sanitizers taken from bulk supplies not clearly / individually identified with the common name of the material. (corrected on site)

Wiping cloths. moist cloths used for wiping food spills on kitchenware and food-contact surfaces of equipment not clean / not rinsed frequently in one of the sanitizing solutions permitted in section 20-21.12(e)(02) through (06) of this code / used for no other purpose. these cloths shall be stored in the sanitizing solution between uses. (corrected on site)

Refrigerated storage. refrigeration facilities. the sensor of a temperature measuring device shall be located to measure the air temperature or a simulated product temperature in the warmest part of the mechanically refrigerated unit and designed to be easily readable.

Cleaning frequency. nonfood-contact surfaces of equipment not cleaned as often as is necessary to keep the equipment free of accumulation of dust, dirt, food particles, and other debris.

Wiping cloths. moist cloths used for wiping food spills on kitchenware and food-contact surfaces of equipment not clean / not rinsed frequently in one of the sanitizing solutions permitted in section 20-21.12(e)(02) through (06) of this code / used for no other purpose. these cloths shall be stored in the sanitizing solution between uses. (corrected on site)

General. plumbing not sized / installed / maintained according to applicable laws.