Space City Birria Tacos and More
Last inspected: Dec 29, 2025
74
Score
Space City Birria Tacos And More, located at 415 Milam St, Houston, TX, had a moderate risk inspection on December 29, 2025, with a score of 74. This inspection identified six minor violations, including issues with customer notification of inspection reports, food storage height, and date marking of refrigerated ready-to-eat foods. Across three scored inspections, the facility has primarily maintained a low-risk status.
4
Inspections
0
Critical latest
0
Major latest
6
Minor latest
Inspection History
Dec 29, 2025
Routine Inspection (001)
6 minor violations.
View 6 violations
8-304.11(k) the permit holder shall notify customers that a copy of the most recent establishment inspection report is available upon request by posting a sign or placard in a location in the food establishment that is conspicuous to customers or by another method acceptable to the regulatory authority.
20-20(c)
General. container of food not stored a minimum of 6 inches above the floor.
20-21.03(a)(02)
Refrigerated storage. date marking of ready to eat foods. time/temperature controlled for safety (tcs) / ready to eat food opened / prepared / packaged and held refrigerated for more than 24 hours not clearly marked to indicate “time food is opened / prepared” and “disposition date”.
20-21.03(b)(10)b
General. contamination event. food establishment without written procedures for employees to follow when responding to vomiting or diarrheal events.
20-21.07(a)(03)
Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.
20-21.10(m)
Hand-washing sink supplies. supply of hand-cleansing liquid / powder / bar soap not available at each hand-washing sink or group of two adjacent hand-washing sinks.
20-21.19(c)
74
Jun 12, 2025
Routine Inspection (001)
6 minor violations. 4 corrected on site.
View 6 violations
Applicability of article; compliance; penalty for violation; variances, etc. permit holder / person in charge of the food establishment / mobile food unit not in compliance in accordance with provisions of article ii concerning food storage / food preparation / food display / training of employees in basic food safety principles including allergy awareness / not ensuring that food and conditional employees are informed of their responsibility to report information regarding health and activities as they relate to diseases that are transmissible through food / not ensuring written procedures and plans are developed by the food establishment are maintained / implemented.
(corrected on site)
20-19(d)
Refrigerated storage. date marking of ready to eat foods. time/temperature controlled for safety (tcs) / ready to eat food opened / prepared / packaged and held refrigerated for more than 24 hours not clearly marked to indicate “time food is opened / prepared” and “disposition date”.
(corrected on site)
20-21.03(b)(10)b
Refrigerated storage. refrigeration facilities. each mechanically refrigerated facility storing time/temperature controlled for safety (tcs) food shall be provided with numerically scaled indicating thermometer, accurate to 3°f if scaled in fahrenheit only. . recording thermometers, accurate to 3°f if scaled in fahrenheit only, may be used in lieu of indicating thermometers. thermometers that are scaled in celsius or dually scaled in celsius and fahrenheit shall be designed to be easily readable and accurate to ±(1.05°c) in the intended range of use.
(corrected on site)
20-21.03(b)(01)
General. contamination event. food establishment without written procedures for employees to follow when responding to vomiting or diarrheal events.
(corrected on site)
20-21.07(a)(03)
Backflow. an air gap between the water supply inlet and the flood level rim of the plumbing fixture / equipment / or nonfood equipment not at least twice the diameter of the water supply inlet and may not be less than 25 mm (1 inch). a backflow or backsiphonage prevention device installed on a water supply system shall meet american society of sanitary engineering (asse) standards for construction, installation, maintenance, inspection, and testing for that specific application and type of device. a backflow prevention device shall be located so that it can be serviced and maintained. a hose shall not be attached to a faucet unless a backflow prevention device is installed.
20-21.17(c)
Food establishment failed to maintain on premises a certificate of completion of the food handler course for each food employee.
20-53(g)
74
Oct 7, 2024
Routine Inspection (001)
3 minor violations. 2 corrected on site.
View 3 violations
General. container of food not stored a minimum of 6 inches above the floor.
(corrected on site)
20-21.03(a)(02)
Insect control devices, design and installation. devices used to trap insects by adherence may not be installed above exposed food / clean equipment / utensils / linens and unwrapped single-service articles.
20-21.21(c)(02)
Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.
(corrected on site)
20-21.23(g)
86
Jan 12, 2024
Routine Inspection (001)
5 minor violations. 1 corrected on site.
View 5 violations
General. container of food not stored a minimum of 6 inches above the floor.
(corrected on site)
20-21.03(a)(02)
Dispensing utensils. no suitable dispensing utensils provided for employees / consumers during pauses in food preparation / dispensing.
20-21.05(f)
Plumbing fixture installation. plumbing fixtures, including compartment type utensil-and-food sinks, hand-washing sinks and mop or utility sinks, not installed to preclude splashes from running down mounting surfaces behind and adjacent to the fixture. acceptable installation methods include a liquid tight seal between fixture and mounting surface, insertion into a precut counter, table or cabinet with a perimeter seal or any other effective method. all materials used shall be safe, smooth, impervious and easily cleanable.
20-21.10(m)
Attachments. light fixtures / vent covers / wall-mounted fans / similar equipment not including decorative items attached to walls and ceilings not easily cleanable / not maintained in good repair / not kept clean.
20-21.23(g)
Locker areas. lockers / other suitable facilities not located in the designated dressing room / in food storage room / other area containing only completely packaged food or packaged single-service articles.
20-21.26(b)
78
Nearby Restaurants